含酚废水处理系统中苯酚降解菌的分离及分离物多样性分析

用富集培养和直接涂平板培养的方法,从含酚废水处理系统的悬浮污泥中分别分离了57株和55株苯酚降解菌.112株分离物经ERIC-PCR指纹图谱分析,共显示了15种差异明显的ERIC-PER指纹图谱,表明至少应有15种不同的菌株.其中直接涂平板法得到的分离物占有11种,富集培养法得到的分离物占4种.将直接涂平板得到的分离物,与来自不同种属苯酚降解菌的LmPH(the largest subunit of multi-component phenol hydroxylase)等位基因分子进行杂交显示,该11种分离物可分为3种以上不同的LmPH代谢类型;而富集培养获得的分离物巾只显示1种LmPH代谢类型.对显示不同ERIC-PCR指纹图的15个代表荫株的生长和苯酚降解效率进行研究发现,其中F-6菌株在苯酚浓度0.4～1.4g·L-1范围内,其苯酚降解效率达到了70%～100%.     

邻苯二甲酸二乙基己酯致OVA致敏大鼠哮喘样病理学改变

全球哮喘患者人数众多,而且这一数字仍在不断增长.近年来大家把目光聚焦到人造化学物质与哮喘增加的关系上.邻苯二甲酸二乙基己酯(di-(2-ethylhexyl)phthalate,DEHP)是现代社会一种常见的污染物,在室内环境中也有广泛的存在.本研究通过建立卵清白蛋白(OVA)致敏的大鼠哮喘模型,来探讨DEHP对哮喘的影响.将Wistar大鼠随机分为6组,分别为生理盐水对照和两种浓度(0.5mg·m-3和5mg·m-3)的DEHP染毒的无OVA致敏组,以及这三者对应的OVA致敏组.行肺部滴注法对大鼠进行染毒,每天1次,染毒剂量相当于在0.5mg·m-3和5mg·m-3浓度的DEHP中暴露8h.处理后的大鼠通过肺功能检测,ELISA检测肺组织细胞因子和肺组织切片等方法研究其哮喘症状.结果显示DEHP染毒的OVA致敏组具有更显著的哮喘症状.     

污泥灰对模拟染料废水的吸附研究

以南京市江心洲污水处理厂污泥为原料热解制得污泥灰,并将其用于吸附直接耐酸大红4BS和活性艳红K-2BP模拟染料废水.考察了吸附剂投加量、吸附时间、温度和pH值对吸附效果的影响,并对其吸附动力学特征进行了探讨.结果表明,反应温度、吸附时间和吸附剂投加量对吸附效果有影响,而废水pH变化则不会引起脱色率的较大改变.室温下,4BS和K-2BP的最佳污泥投加量分别为3g·L-1、10g·L-1.4BS在最佳反应条件（反应时间为25min,反应温度为40℃）下,脱色率可达93%;K-2BP在最佳反应条件（反应时间为150min,反应温度为40℃）下,脱色率约为73%.     

A+OSA活性污泥工艺剩余污泥减量特性研究

采用自动热量计对Anoxic (A) + oxic-settling-anaerobic(OSA)系统解偶联池进出污泥进行热值分析,以考察污泥量变动与能值变动的相互关系;通过解偶联池参数调整,了解污泥减量趋势,结合能量和物质平衡与常规水质指标测试,推测减量途径和特性.结果表明,解偶联池水力停留时间为5.56、 7.14和9 h时,整个系统污泥减量分别为1.236、 0.771和0.599 g/d.进出解偶联池的污泥含能水平发生了变化,随停留时间增加出流污泥的单位热值有高于进流污泥单位热值的趋势：5.56 h时,进出水热值没有显著差异;7.14 h时,进出水热值差值在99～113 J/g之间;9 h时,差值在191～329 J/g之间.解偶联池发生了污泥的衰减,停留时间延长,衰减程度越高.A+OSA系统污泥减量是解偶联池污泥衰减与AO主体反应区污泥产生率变化共同作用的结果.     

川渝地区农业生态系统NH3排放

基于县级农业活动水平数据及区域氮循环模型IAP-N方法,并根据地理特征、环境气候条件及地区行政区划将川渝地区划分成4个亚区,详细估算了1990~2004年川渝地区农业生态系统各氨排放源的排放及其时空分布状况.结果表明,1990~1994、1995~1999和2000~2004年3个时期,整个川渝地区农业生态系统氨(NH3)年均排放量(以纯氮量计)分别为626.7、670.5和698.8 Gg.a-1.氨排放年际变化呈增长趋势,各氨排放源贡献率的年际变化不大,2000~2004年川渝地区施肥农田、粪便管理系统和秸秆燃烧氨排放源的贡献率分别为53%、46%和1%,排放量分别为374.9、318.2和5.6 Gg.a-1.各地区的氨排放源结构有所不同,成都平原和重庆地区施肥农田氨排放贡献率最高,而川西南地区和川西北地区以粪便管理系统氨排放为主.川渝地区农业生态系统氨排放地理分布总体上呈"东高西低"现象,2000~2004年,重庆丘陵地区、成都平原地区、川西南山地区及川西北高原地区的氨排放量分别为165.6、408.8、85.9和38.8 Gg.a-1,氨排放强度分别为20、28、9.1和1.6kg.(hm2.a)-...     

European scale application of atmospheric reactive nitrogen measurements in a low-cost approach to infer dry deposition fluxes

A European scale network was established in 2006 as part of the NitroEurope Integrated Project to infer reactive nitrogen (Nr) dry deposition fluxes, based on low-cost sampling of gaseous and aerosol species and inferential modelling. The network provides monthly measurements of NH₃, NH₄⁺, HNO₃ and NO₃⁻, as well as SO₂, SO₄²⁻, HCl, Cl⁻ and base cations at 58 sites. Measurements are made with an established low-cost denuder methodology (DELTA) as a basis to: (1) examine temporal trends and spatial patterns across Europe, (2) improve and calibrate inferential modelling techniques to estimate exchange of Nr species, (3) provide best estimates of atmospheric dry N deposition, and (4) permit an analysis of net GHG exchange in relation to atmospheric and agricultural N inputs at the European scale. Responsibility for measurements is shared among seven European laboratories. An inter-comparison of the DELTA implementation by 6 laboratories at 4 test sites (Montelibretti, Italy; Braunschweig, Germany; Paterna, Spain and Auchencorth, UK) from July to October 2006 provided training for the laboratories and showed that good agreement was achieved in different climatic conditions (87% of laboratory site-means within 20% of the inter-laboratory median). Results obtained from the first year of measurements show substantial spatial variability in atmospheric Nr concentrations, illustrating the major local (NH₃) and regional (HNO₃, NO₃⁻, and NH₄⁺) differences in Nr concentrations. These results provide the basis to develop future estimates of site-based Nr dry deposition fluxes across Europe, and highlight the role of NH₃, largely of agricultural origin, which was the largest single constituent and will dominate dry Nr fluxes at most sites.     

A new approach to predicting the maximum temperature in dry drilling based on a finite element model

A new analysis approach is developed to predict the temperature in dry drilling. The working rake angle and the working relief angle which the effect of feed is considered at an arbitrary point in the leading cutting edge of a twist drill are developed for the equivalent model. Then finite element models are developed to predict the drilling temperature based on the equivalent model. Commercial finite element codes Abaqus, Deform 2D and Third Wave Systems AdvantEdge have been used. In simulations, different chip separation models and material models are applied in the three codes. And the effect of the laws of drilling velocities and feed rates on the temperature are investigated by the finite element method. Predicted results of the maximum temperatures by three codes are compared with experiments, respectively. Results indicate that the drilling temperature results of simulations have good agreement to the experimental ones, and the errors are all less than 15%.     

废弃钻井液固化处理pH值控制措施

提出了在原有固化处理技术的基础上,根据钻井泥浆原样pH值的高低,在固化材中适量加入酸性盐类混凝剂有效控制pH值的方法。采用此方法后,废弃钻井液的固化处理效果好,能够满足环保标准要求。     

浅谈液化气钢瓶(罐)灭火抢险技术

介绍了液化石油气的性质、火灾特点以及液化石油气钢瓶、液化石油气储罐的灭火抢险技术。     

油库中油品的蒸发危害及措施

分析了造成油库油品蒸发损耗的原因及危害,并针对油罐的自然通风、“小呼吸”、“大呼吸”所造成的油品损耗,提出了降低油品蒸发损耗的措施。